#1
Tools
needed: logo, drum head, X-acto knife, masking tape, credit
card, phone book.
|
#2
Visually
place logo & apply two pieces of tape to hold logo to drum
head.
|
#3
Apply
a strip of tape down the long edge of the logo, hinging it to
the drum head.
|
|
#4
Cut
off excess logo material making sure to leave about 1"
of material extending beyond the metal edge of the drum head
|
#5
Flip
logo over & peel the contact sheet off, to expose logo and
the adhesive transfer tape.
|
#6
Using
your hand, slowly smooth the logo down with a sweeping motion
back & forth, to lightly adhere logo to the drum head surface.
|
|
#7
Place
phone book under drum head to provide a firm surface. Using
a credit card, push hard over the logo a few times to adhere
it to the drum head. (Note: There will be a slight color change
in the logo as it adheres to drum head
|
#8
Push
the ends of the logo down into the groves at the edge of the
rim using your fingers. Using your finger, push hard over the
logo a few times to adhere it to the drum head.
|
#9
Using
the X-acto knife, carefully trim off the excess material, using
the gutter as a guide.
|
|
#10
Turn
head over onto a firm smooth surface. Once again, use the credit
card to push hard over the logo a few times to adhere it to
the drum head.
|
#11
Slowly
peel the backing tape off at an angle. Don't pull straight up.
Keep the transfer tape close to the head.
|
Logos
can be
applied in less
than 10 minutes
|
